2007 International 4300 Transmission Fluid Capacity: Blunt and Straightforward Information

2007 International 4300 Transmission Fluid Capacity

Introduction

If you own a 2007 International 4300 truck, it’s important to know the transmission fluid capacity to ensure proper maintenance and performance. In this article, we will provide you with the blunt and straightforward information you need, without any sugarcoating. So, let’s get straight to the point!

Transmission Fluid Capacity and Type

To keep your International 4300 running smoothly, you need to know the correct transmission fluid capacity and type. Here’s a table that provides you with the necessary information:

Transmission Fluid Capacity (Quarts) Capacity (Liters)
Automatic Transmission 16 quarts 15.1 liters
Manual Transmission 8 quarts 7.6 liters

Transmission Fluid Replacement

Now that you know the transmission fluid capacity, let’s discuss how to replace it. Remember, safety is crucial, so make sure to follow these steps carefully:

  1. Ensure the truck is parked on a level surface and the engine is turned off.
  2. Locate the transmission fluid dipstick, usually located near the back of the engine compartment.
  3. Using a funnel, remove the dipstick and add the appropriate amount of transmission fluid according to the capacity mentioned in the table above.
  4. Check the fluid level using the dipstick. It should be within the recommended range.
  5. If the level is low, add more fluid until it reaches the correct level.
  6. Replace the dipstick and securely tighten it.
  7. Start the engine and let it run for a few minutes to allow the fluid to circulate.
  8. Check the fluid level again and adjust if necessary.

Conclusion

Knowing the transmission fluid capacity for your 2007 International 4300 is essential for proper maintenance. By following the blunt and straightforward information provided in this article, you can ensure that your truck’s transmission performs optimally. Remember to always prioritize safety and follow the recommended steps when replacing the transmission fluid.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top