2013 F250 Transmission Fluid Capacity: Blunt and Straightforward Guide

2013 F250 Transmission Fluid Capacity

If you’re looking to change the transmission fluid in your 2013 F250, it’s important to know the correct capacity to ensure optimal performance. In this article, we’ll provide you with the blunt and straightforward information you need, without any sugarcoating. So, let’s get straight to the point.

Transmission Fluid Capacity and Type

To determine the transmission fluid capacity for your 2013 F250, refer to the table below:

Transmission Fluid Type Quarts Liters
6R140 TorqShift 17.5 16.6

As you can see, the 2013 F250 with the 6R140 TorqShift transmission requires approximately 17.5 quarts or 16.6 liters of transmission fluid. It’s crucial to use the correct type of fluid to ensure proper lubrication and performance.

Changing the Transmission Fluid

Now that you know the transmission fluid capacity, let’s briefly discuss how to change it. However, please note that working with transmission fluid can be hazardous, so exercise caution and follow safety guidelines.

  1. Start by parking your F250 on a level surface and engaging the parking brake.
  2. Locate the transmission fluid dipstick, usually located near the back of the engine bay.
  3. Using a suitable tool, remove the dipstick and set it aside.
  4. Prepare a drain pan that can hold at least 18 quarts of fluid.
  5. Locate the transmission fluid drain plug, which is typically located on the bottom of the transmission pan.
  6. Place the drain pan beneath the drain plug and carefully remove it, allowing the fluid to drain completely.
  7. Once the fluid has drained, replace the drain plug and tighten it securely.
  8. Using a funnel, add the recommended amount of new transmission fluid through the dipstick tube.
  9. Check the fluid level using the dipstick, ensuring it is within the appropriate range.
  10. If necessary, add more fluid in small increments until the level is correct.
  11. Finally, replace the dipstick and start the engine, allowing it to idle for a few minutes.
  12. Shift through each gear, pausing briefly in each one, and then return to Park.
  13. Check the fluid level again and adjust if needed.

Remember, always consult your vehicle’s owner’s manual for specific instructions and safety precautions. If you’re unsure or uncomfortable performing this task, it’s best to seek professional assistance.

Conclusion

Knowing the correct transmission fluid capacity for your 2013 F250 is essential for maintaining its performance and longevity. By following the blunt and straightforward steps outlined in this article, you can confidently change the transmission fluid and keep your truck running smoothly. Just remember to prioritize safety and exercise caution throughout the process.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top