2016 Honda CRV Transmission Fluid Change Guide

2016 Honda CRV Transmission Fluid Change Capacity

Introduction

If you own a 2016 Honda CRV and are wondering about the transmission fluid change capacity, you’ve come to the right place. In this article, we will provide you with all the information you need to know about the transmission fluid capacity for your Honda CRV.

Transmission Fluid Capacity and Type

To ensure optimal performance and longevity of your Honda CRV’s transmission, it is essential to use the correct transmission fluid and maintain the appropriate fluid level. Here is a table detailing the transmission fluid capacity for the 2016 Honda CRV:

Transmission Fluid Type Fluid Capacity (Quarts) Fluid Capacity (Liters)
Honda ATF DW-1 3.1 quarts 2.9 liters

Transmission Fluid Change Procedure

Now that you know the transmission fluid capacity for your Honda CRV, let’s discuss the steps involved in changing the transmission fluid:

  1. Ensure your vehicle is parked on a level surface and the engine is turned off.
  2. Locate the transmission fluid dipstick, which is usually labeled and located near the engine bay.
  3. Using a clean cloth or paper towel, remove the dipstick and wipe it clean.
  4. Reinsert the dipstick fully and then remove it again to check the fluid level. The fluid should be between the minimum and maximum marks on the dipstick.
  5. If the fluid level is below the minimum mark or appears dirty or discolored, it is time to change the transmission fluid.
  6. Locate the transmission fluid drain plug underneath the vehicle. Place a drain pan underneath to catch the old fluid.
  7. Remove the drain plug and allow the old fluid to drain completely.
  8. Once the fluid has drained, reinstall the drain plug securely.
  9. Locate the transmission fluid fill plug, which is typically located on the side of the transmission.
  10. Using a funnel, carefully pour the recommended amount of Honda ATF DW-1 transmission fluid into the fill plug opening.
  11. Reinstall the fill plug securely.
  12. Start the engine and let it idle for a few minutes.
  13. With the engine still running, check the transmission fluid level using the dipstick. Add more fluid if necessary to reach the optimal level.
  14. Finally, replace the dipstick and ensure it is securely in place.

Conclusion

Regularly changing the transmission fluid in your 2016 Honda CRV is crucial for maintaining the health and performance of your vehicle’s transmission. By following the steps outlined in this article and using the recommended transmission fluid, you can ensure that your Honda CRV continues to run smoothly for years to come. Remember, it’s always better to be proactive when it comes to vehicle maintenance rather than waiting for problems to arise.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top