Transmission Fluid Capacity for S10 T5 Transmission: A Guide to Proper Maintenance

Transmission Chevy Fluid Capacity for S10 T5 Transmission

When it comes to maintaining your S10 T5 transmission, one important aspect to consider is the transmission fluid capacity. Knowing the correct amount of fluid to use is crucial for optimal performance and longevity of your transmission. In this article, we will provide you with the necessary information on the transmission fluid capacity for the S10 T5 transmission.

Transmission Fluid Type

Before we dive into the fluid capacity, let’s first discuss the type of transmission fluid you should use for your S10 T5 transmission. It is essential to use the right fluid to ensure proper lubrication and cooling of the transmission components. For the S10 T5 transmission, the recommended fluid type is Dexron III/Mercon ATF (Automatic Transmission Fluid).

Transmission Fluid Capacity

Now, let’s get to the heart of the matter – the transmission fluid capacity for the Chevy S10 T5 transmission. The table below provides the fluid capacity in both quarts and liters:

Transmission Fluid Capacity Quarts Liters
S10 T5 Transmission 2.8 quarts 2.6 liters

As you can see, the S10 T5 transmission requires approximately 2.8 quarts or 2.6 liters of transmission fluid. It is important not to overfill or underfill the transmission, as both scenarios can lead to performance issues and potential damage.

Fluid Change Procedure

If you need to change the transmission fluid in your S10 T5 transmission, here’s a straightforward procedure to follow:

  1. Ensure your vehicle is on a level surface and the engine is turned off.
  2. Locate the transmission fluid pan underneath the vehicle.
  3. Place a drain pan beneath the transmission fluid pan to catch the old fluid.
  4. Remove the bolts securing the transmission fluid pan and carefully lower it to drain the fluid.
  5. Once the fluid has drained completely, clean the pan and replace the transmission filter if necessary.
  6. Reinstall the transmission fluid pan and tighten the bolts securely.
  7. Locate the transmission fluid dipstick and remove it.
  8. Using a funnel, add the recommended amount of Dexron III/Mercon ATF into the transmission.
  9. Check the fluid level using the dipstick and add more fluid if needed.
  10. Replace the dipstick and start the engine.
  11. Allow the engine to idle for a few minutes and then shift through all gears to circulate the fluid.
  12. Check the fluid level once more and adjust if necessary.

Following these steps will ensure a proper transmission fluid change for your S10 T5 transmission, helping to maintain its performance and durability.

Conclusion

Knowing the correct transmission fluid capacity for your S10 T5 transmission is essential for its proper functioning. By using the recommended Dexron III/Mercon ATF and following the fluid change procedure, you can ensure that your transmission stays in top shape. Remember, maintaining your transmission is crucial for the overall performance and longevity of your vehicle, so don’t neglect this important aspect of maintenance.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top